When Ghost MV1 was unveiled to the vaporizer community, it got everyone’s attention. The eye-catching design, on-demand convection heating and other unique features were embraced by vape users. This vape takes some getting used to; however, our Ghost MV1 quickstart guide will get you vaping quickly. If you are already using this impressive vape, the following tips and trick will help you get the most out of this amazing portable vaporizer.

MV1’s Adjustable Airflow

The MV1 features a clear mouthpiece that easily slides into and out of the heatsink. This set up allows you to set the resistance and protect the unit while it is stashed into your pocket. The extended mouthpiece allows for more open draws. If you push it closer to the heatsink, the resistance increases. We found that the sweet spot is in the middle. There is an indent on the mouthpiece that allows it to sit a half to three-quarter of an inch from the heatsink. As you begin using your MV1 vaporizer, you will find the sweet spot that provides you with the perfect draw.

Ghost MV1 Vaporizer
Ghost MV1 Vaporizer

Choose a Custom Temperature

The MV1 comes with five different herbal temperature settings and one concentrate temperature setting when you take it out of the box. You can also customize the fourth and fifth heat settings using the smartphone app. Check out our Ghost MV1 app guide to learn about the pairing process and the other features that the app offers.

Flipping the Crucible

Typically you will not need to stir your MV1 during your session; however, to ensure you maximize the enjoyment of your session, we have a handy tip for you. Allow your crucible to cool down for a few minutes. Then remove it from its holder and rotate the crucible 180 degrees. Rotating the crucible heats the cooler side of the burner for maximum enjoyment. Doing this is similar to rotating food around on a grill for even cooking.

Properly Seating Your Heatsink

If you feel like your Ghost MV1 is not pulling as it did in the past, it may be due to your heatsink. Press down on the top of the heatsink to ensure that it is fully seated in your vaporizer. The top of the heatsink should be level. Although this should not be an issue, it can occur when you adjust or clean your vape. Therefore, if the draw on your vape is not the same as it used to be, make sure your heatsink is firmly fitted.

Begin Vaping Sooner

If you want to increase the flavour, begin drawing on your MV1 vape for a few seconds before the second sound indicates that the vaporizer is ready to use. This will not give you as much vapour as you are accustomed to; however, you will notice an enhancement of the flavour of your herbs. It is quite similar to the Fury 2 Vaporizer when it comes to vapor quality.

VapoShop - Europe's #1 vaporizer webshop
Mighty Vaporizer vs Ghost MV1
Mighty Vaporizer vs Ghost MV1

Finish Late

If you desire a headier hit from your Ghost MV1, keep vaping once the active mode shuts off. You can release the button and then press it again immediately to provide you with a second hit. However, try not to overdo it or you can overheat the MV1 and your precious herbs.

Using Concentrates

Some herbal vaporizers struggle to handle concentrates. the Ghost MV1 easily handles these stickier substances thanks to their specially designed concentrate heat setting and concentrate pads.  It is a lot like Pax 3 Vaporizer in that regard as it is just as good at concentrates as well as dry herb.

Crucible Dispenser

A crucible dispenser is an optional accessory that you may want to consider. This accessory provides you with a way to extend the MV1’s battery life. You can load five crucibles for on the go loading. Simply swap them out as you need them. Crucibles are loaded upside down which allow you to quickly see which crucibles have been used.

Written by 

Leave a Reply